Wheel Spacers - Alloy - Set of 4

Terrafirma 30mm alloy wheel spacers complete with high tensile studs and a complete set of retaining nuts 5x165 PCD. (Set of 4)

Fitting Instructions

1. Put the car into gear and apply the hand brake, loosen front wheel nuts, raise vehicle on a jack and then
support the front axle on axle stands.
2. Remove the front wheels.
3. Bolt the wheel spacer to the hub using the new wheel nuts supplied and torque the nuts to 130Nm or 96lb/ft.
4. When both sides are done refit wheels lower the car off of the axle stands and torque the wheel nuts to
130Nm or 96lb/ft.
5. Loosen rear wheel nuts, raise vehicle on a jack and then support the rear axle on axle stands.
6. Remove the rear wheels.
7. Bolt the wheel spacer to the hub using the new wheel nuts supplied and torque the nuts to 130Nm or 96lb/ft.
8. When both sides are done refit wheels lower the car off of the axle stands and torque the wheel nuts to
130Nm or 96lb/ft